You might also like to check out the ‘techniques’ section on here. So, in that case, choose the best size to work with your other beads. Remember how I said the cover would look like ‘just another bead’? Well, you might like to make it part of your design. But you can also use a larger cover if you are working on a project with larger beads. So, you should size the cover according to the crimp, naturally. You will find you have a choice of sizes for your crimp covers. If you’re happy shopping online, then I can recommend this supplier. Most good bead shops will sell all the findings you need for any project. Just be careful – you don’t want to break or scratch any of the neighbouring beads and components.Īs with anything, this is a skill that just takes a little time and practice to master. In this instance, you might want to try pliers with a narrower jaw. You will have other beads and clasp near the crimp, so that can leave you less room to get access with your pliers. But it will get a little trickier on an actual piece of jewellery. This may not feel too bad on a lone sample. I’ve shown this process, but of course, I haven’t shown you on an actual sample in the photos, so you will need to imagine your closed crimp with its beads and clasp either side of it. Keep pushing until the edges meet and your cover is completely closed. Gently squeeze the pliers, squashing the edges of your cover towards one another. Carefully take your pliers – I prefer to use flat-nosed – and position them around the sides of your cover. Then, place the crimp inside, supporting it in place. These provide the perfect finishing touch.īasically, I find it easiest to lay the back of the cover on my finger. ![]() So, when you have completed your stringing, and sealed the crimps to hold everything in place, it’s time to bring out your covers. They’re not expensive, so it may be worth trying a few on samples to get used to using them, before you add them to your best jewelry project. But, like other small findings, they can feel a little tricky at first. Happily, crimp covers are very easy to use. The cover will also help to protect your crimp bead from wear and tear, hopefully making your jewellery last longer. So, by covering them, you don’t have to worry. If the crimp is not straight before crimping, you will get an uneven result that may not grip the wire, may be subject to breakage, and may permanently bend the beading wire.If you’ve ever used a crimp bead, you’ll know that they don’t always close shut in the neatest possible manner. Your loop should be secure and permanent. Carefully squeeze down on your pliers and squash crimp flat. Hold your pliers at a right angle to your wire. ![]() Next, either use specialty crimping pliers and follow the instructions that come with them, or use the flat nosed pliers as follows: Line up the crimp in the tip of your pliers as straight as possible. ![]() Now is the time to pull the loop as tight as you want it to be, because after you finish crimping, the loop will be permanently fixed. Pass the end of the wire back through the crimp, so that the loop of wire is closed. Loop the wire around your clasp or jump ring (the thing you want to put on the very end of the wire). To use crimps, you will need some flat nose pliers to squash the crimps, or speciality crimping pliers that "fold" the bead into a small volume.įirst, thread crimp onto wire. Crimp beads are soft metal beads used in place of knots to secure clasps and beads onto un-knottable stringing material such as beading wire.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |